STAIN REMOVAL
PYRATEX LV

Sets a new standard for easy, efficient & effective dry-side stain removal
Oil-Based Paints, Heavy Oil & Grease, Nail Polish, Correction Fluid, Shoe Polish, Mascara, Crayon, Lipstick, Ink, Tar, Lacquer

Pre-Spotting
1. Apply PYRATEX LV to the stained area.
2. Work gently with spatula or tamp with spotting brush until stain is completely loosened or removed. If stain spreads, place a clean towel underneath the stain. Flush with PYRATEX LV until bleeding stops.
3. Dryclean, wetclean or launder as normal. No flushing is required when used with perc, hydrocarbon, wetcleaning or laundry.
Note: When used in conjunction with GreenEarth® (D5) solvent, PYRATEX LV must be flushed with GreenSPOT™, steam or water prior to drycleaning.
When used in conjunction with other solvents, PYRATEX LV must be flushed completely from fabric prior to drycleaning.

Post-Spotting
1. Apply PYRATEX LV to the stained area.
2. Work gently with spatula or tamp with spotting brush until stain is completely loosened or removed. If stain spreads, place a clean towel underneath the stain. Flush with PYRATEX LV until bleeding stops.
3. Flush area thoroughly with steam or water utilizing vacuum from spotting board.
4. Dry using air gun.

For Lipstick or Ink Loads
Perc and hydrocarbon solvents only
Add one quart of PYRATEX LV for every 5 gallons of solvent in the wheel and run a batch cycle at low level without filtration.
1. Clean for 20 minutes in perc or 30 minutes in hydrocarbon solvent.
2. Drain and extract to still.
3. Dryclean as normal.
This should remove the vast majority of lipstick or ink stains. The last traces can be manually removed on the spotting board.

SIZE: 1G